Firmware Upgrade Procedure; Order Of Upgrade - FLIR CM-6308-P1-I Firmware Release Notes

4 Firmware Upgrade Procedure

Note:
It is recommended to:
1. Clear the browser's cache
2. Remove the existing Ariel player before accessing the camera.
3. On the first time that the camera is upgraded with the new firmware, it will backup its
stitching table. This process would take 15-20 minutes, during which the camera would be
accessible but not usable. Do not reboot the camera during this process.
The camera's firmware can be updated by using the Discovery Network Assistant (DNA) tool or over the
web from the unit's web interface. It is recommended to use DNA firmware version 2.2.1.9 or higher to
upgrade from a previous firmware version.
Note:
The firmware for the FPGA can only be upgraded from the web UI. if a CM-IMG5-63P is to be used, do
not physically install it until indicated as part of the firmware upgrade steps below.
It's highly recommended not to downgrade any of the camera's firmware.

4.1 Order of Upgrade

4.1.1 Multi-imager unit is currently on firmware 20171218
1. Upgrade the camera firmware via the web UI or DNA using file CM-6308-P1-I_20190226.bin.
2. If a CM-IMG5-63P is going to be used, set the camera in 360 mode (by adjusting it physically)
and attach the accessory.
3. Upgrade the FPGA from the web UI using the file flirpano_a7_29171533_cs.bit.
4.1.2 Multi-imager unit is currently on firmware 2018xxxx (beta)
1. If a CM-IMG5-63P is going to be used, set the camera in 360 mode (by adjusting it physically)
and attach the accessory.
2. Upgrade the camera firmware via the web UI or DNA using file CM-6308-P1-I_20190226.bin.
3. Upgrade the FPGA from the web UI using the file flirpano_a7_29171533_cs.bit.
4.1.3 Multi-imager unit is currently on firmware 20190226 and installing a CM-IMG5-63P
1. If a CM-IMG5-63P is going to be used, set the camera in 360 mode (by adjusting it physically)
and attach the accessory.
2. Upgrade the camera firmware via the web UI or DNA using file CM-6308-P1-I_20190226.bin.
3. Upgrade the FPGA from the web UI using the file flirpano_a7_29171533_cs.bit.
April 2, 2019 CM-6308-P1-I FW v.20190226 Release Notes
Firmware Upgrade Procedure
7