Advertisement
! The proper sealed and hermetic gaskets must be used for spacing connection.
! Inspect and compare the gas inlet pressure values and the gas inlet values of the
building. These adjustments are only performed by Baykan Service Headquarters and
Baykan authorized personnel.
! Do not forget to let the air in the gas pipe out.
NOTE: When the conversion from natural gas to L.P.G. is being performed, the burner jets
suitable for L.P.G. must be changed. The gas inlet pressure should not exceed 60mbars.
ENSURE THAT THE GAS AND WATER CONNECTING PIPES HAVE NOT BEN USED FOR
GROUNDING PURPOSES. IN SUCH CASES, DO NOT OPERATE THE WALL HUNG BOILER.
DISCONNECT THE GROUNDING. SITUATIONS DANGEROUS FOR YOUR DEVICE MAY ARISE
AT SUCH CASES.
2.3 ELECTRICITY CONNECTION
The supply cable of your device is delivered to you as connected to the unit. The external
electricity connection of the cable must be made by a qualified electrician in conformity with the
regulations and standards in effect.
The manufacturer company is not liable for the damages which may arise due to non-
standard electricity connection and grounding maps.
! As electricity cables, use NYM 3x1,5 mm2 Phase, Neutral, soiling. ! Use a 3 Amper fuse.
CAUTION: CONNECT YOUR DEVICE TO BIPOLAR SOCKETS.
Do not operate your device with multiple sockets and adapters.
If the electricity cables need to be replaced, the cables having the same properties and
specifications must be used. If there is a need for changing the cable, comply with the signs on the
main input connector.
! Please connect the blue cable to the connector marked with 'N'.
! Connect the brown cable to the connector marked with letter 'L'.
! Connect the yellow/green cable to the connector signed with grounding sign. ! While changing
the cable, use the specified cables, H05VVF,H05-VVH2-F
2.4 ROOM THERMOSTAT CONNECTION
! Have the room thermostat connection of the device you purchased from Baykan or delivered to
you with the device serviced by authorized technical service personnel. Connect the cable
from the room thermostat to the poles of connectors seen in diagram 7 correctly.
! In case of connecting the external probe, connect the cable from outdoor thermostat to the
poles of connectors seen in diagram 7.
! 13
Hide quick links:
Advertisement
