Table of Contents
Advertisement
Limitless™ WGLA Series
50051863
Issue 2
6.6 WGLA Mounting/Mechanical Actuators
The WGLA housing has four mounting holes that will accept a M5 or #10 size screw. Two of the mounting holes are
slotted to allow adjustment of the switch actuator to the customer actuator during installation. It is suggested that the
two slotted holes have screws installed and adjustment be made before installing screws in the non-slotted holes.
Note: The adjustment process should not allow preload of the switch actuator and the full travel of the switch
actuator should not exceed the switch over travel maximum specification. (See installation drawing at
www.honeywell.com/sensing)
Figure 23. Limitless™ WGLA mounting hole diagram
The WGLA Series switch has many actuator types and associated specifications (see below).
Additional information regarding the instructions for reading of the bar charts can be found at:
www.honeywell.com/sensing
30
Honeywell Sensing and Control
Advertisement
Table of Contents
