Limitless™ WGLA Series
Step
Action
1
Remove the two screws
2
Remove old battery from the battery holder
lever on the holder's side slots.
3
Install battery as follows to avoid damage to the battery and holder:
• See label in battery holder defining the "+" and "-" terminals
with correct polarity.
• Do not attempt to bend the battery's hold-down tabs forward.
• Insert the battery negative end under the hold-down tab, at an angle, and against the end of the
spring tab
spring tab, and angle the positive end into the holder
4
Replace cover and retighten screws
5
Dispose of used battery promptly per local regulations or the battery manufacturer's recommendations. Keep
away from children. Do not disassemble and do not expose of in fire.
Note: Re-pairing via pairing mode is not required after installing a new battery
Figure 25. Limitless™ WGLA Battery Replacement
34
Honeywell Sensing and Control
on the housing cover.
. Simultaneously move the negative end of the battery into position, compressing the
.
. If needed, pry out battery by using a slotted screwdriver as a
.
50051863
Issue 2
to ensure battery is placed in holder