Victor 6056B User Manual page 29

cloth and mild detergent rather than strong solvents
as abrasive, alcohol, etc;
1-5. If the battery is not used for long, please take it out
in order to prevent the leakage from corroding this
meter;
1-6. Do not use DC or AC peak voltage more than
1000V;
1-7. Never measure voltage values at the current gear,
resistor gear, diode gear and buzzer gear;
1-8. Do not use this meter before the battery is not
installed properly or the back lid is not inserted
tightly;
2. Battery installation or replacement
Please pay attention to the use condition of 9V battery
during use; when the "
or power-on is not available, please replace the battery
according to the following figure.
The steps are shown as below:
2-1. Switch off this meter and remove the test probe in
the input terminal or current lead clamped in.
2-2. Let the panel of this meter faced down and screw
out the screws on the battery lid and remove the lid.
"sign appears on the display
27