5.
Move the section-valve manifold and gaskets
down to clear the section-bypass valve and then
away from the machine
Note:
If needed, loosen the mounting hardware
for the left or right section-valve manifolds as
needed to provide clearance.
Note:
Retain the flange clamps, gaskets and
quick-connect pins for installation in
the Agitation-Manifold Valve (page
Cleaning the Manifold Valve
1.
Position the valve stem so that it is in the closed
position
(Figure
Figure 115
1. Valve open
2.
Remove the 2 end-cap-fitting assemblies from
each end of the manifold body
Figure
117).
(Figure
114).
Installing
85).
115B).
2. Valve closed
(Figure 116
1. Stem retainer
2. Valve stem
3. Stem port
g027562
4. Stem-capture retainer
5. End-cap fitting
6. End-cap seal O-ring
(0.796 x 0.139 inch)
and
82
Figure 116
Agitation Valve Manifold
7. Back seating O-ring (0.676
x 0.07 inch)
8. Valve-seat ring
9. Manifold body
10. Ball valve
11. End-cap-fitting assembly
g028243