Toro Multi Pro 5800-G Operator's Manual page 37

Figure 43
1. Manual mode position
3. Set the master section switch to the O
position; refer to Figure 41
Application Rate Mode (page
4. Adjust the throttle to the desired engine speed
to spray; refer to Figure 42
Application Rate Mode (page
5. Drive to the spraying location.
6. Lower the sections into position.
7. Set the individual section switches, as needed,
to the O position; refer to
N
in the Application Rate Mode (page
8. Use the application-rate switch to achieve the
desired spray pressure as indicated in the
nozzle-selection guide provided with the sprayer
(Figure 44).
Figure 44
1. Application-rate switch
9. Drive at the desired speed and then set the
master section switch to the O
spraying; refer to Figure 41
Application Rate Mode (page
Note:
When the tank is nearly empty, the
agitation may cause foaming in the tank. In
g195516
2. Sprayer-mode switch
FF
in Spraying in the
35).
in Spraying in the
35).
Figure 41 in Spraying
35).
g195528
position to begin
N
in Spraying in the
35).
this case, turn the agitation switch to the O
position. Alternatively, you can add anti-foaming
agent to the tank.
10. When you are finished spraying, set the master
section switch to the O
sections, then set the spray-pump switch to the
O position.
FF
Note:
Return the sections to the transport
position and drive the sprayer to the cleaning
area.
Important:
Always raise the sections
until they have moved completely into
section-transport cradle forming the "X"
transport position and the section cylinders
are fully retracted whenever you move the
sprayer from 1 spraying area to another, or
move to a storage or cleaning area.
Catch Test
Customer provided equipment: A graduated
catch container (a container with 0.01 ml (1/2 fl. oz)
increments is preferred) and stop watch.
Preparing for the Catch Test
Important:
Whenever possible, do not use
reclaimed water (gray water) in the spray tank.
1. Ensure that the sprayer tank is clean; refer to
Cleaning the Sprayer System (page
2. Fill the sprayer tank with at least 568 L (150 US
gallons) of fresh water; refer to
Tank (page 27).
3. Ensure that the nozzles that you intend to test
are in the active spray (down) position.
4. For machines operated in the application-rate
mode, ensure that the knob for the
section-bypass shutoff valve is in the closed
position (Figure
37
position to turn off all
FF
41).
Filling the Spray
45).
FF