Toro Multi Pro 5800-G Operator's Manual page 26

When you spray at a higher application rate, consider
using a coarser optional pressure-filter mesh; refer
to Figure 23.
Mesh size—application rate
1. Higher application rate
2. Lower application rate
Selecting a Nozzle-Tip Filter
(Optional)
Note:
The use the optional nozzle-tip filter to protect
the spray-nozzle tip and increase its service life.
Use the nozzle-tip filter table to identify the screen
mesh for the spray nozzles you are using based
on chemicals products or solutions with a viscosity
equivalent to water.
Nozzle-Tip Filter Table
Spray Nozzle Filter Mesh Size*
Color Code (flow
rate)
Yellow (0.2 gpm) 100
Red (0.4 gpm) 50
Brown (0.5 gpm) 50
Gray (0.6 gpm) 50
White (0.8 gpm) 50
Blue (1.0 gpm) 50
50
Green (1.5 gpm)
*The mesh size of the nozzle filters in this table
are based on spray chemicals or solutions with the
viscosity equivalent to water.
Important:
When you spray with higher viscosity
(thicker) chemical products or solutions with
wettable powders, you may need to use a coarser
screen mesh for the optional tip-filter; refer to
Figure 24.
Figure 23
3. Screen mesh size
Filter Color Code
Green
Blue
Blue
Blue
Blue
Blue
Blue
Mesh size—chemical or solution viscosity
g214240
1. Higher-viscosity chemicals
or solutions
2. Lower-viscosity chemicals
or solutions
When you spray at a higher application rate, consider
using a coarser tip-filter mesh; refer to
Mesh size—application rate
1. Higher application rate
2. Lower application rate
26
Figure 24
3. Screen mesh size
Figure
Figure 25
3. Screen mesh size
g214245
25.
g214245