Table of Contents
Advertisement
2. In the menu choose: Steam
Cleaning.
3. Turn on the function: Descaling.
The display shows the duration of the
function.
The signal sounds when the programme
is completed.
4. Press the sensor field to turn off the
signal.
5. Remove the remaining water from
the steam generator.
6. Leave the oven door open for
approximately 1 hour. Wait until the
oven is dry. You can heat up the
oven with hot air at temperature 150
°C for approximately 15 minutes to
speed up drying.
12.5 Removing and installing
door
Remove the door to clean the inner side
of the oven more easily.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully release the clamping levers on
the hinges.
4
3
3. Hold the door on the two sides and
close it approximately 3/4 of the way.
4. Pull the door away from the oven.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
When the cleaning is completed, install
the door.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
6. Hold the door on the two sides at an
7. At the same time push the door
8. Lift the door up until you are at the
9. Fully lock the clamping levers on the
10. Close the door.
12.6 Replacing the lamp
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
2
The side lamp
1. Remove the left shelf support to get
2. Use a Torx 20 screwdriver to remove
3. Remove and clean the metal frame
4. Replace the lamp with a halogen,
5. Install the metal frame and the seal.
6. Install the left shelf support.
angle of approximately 60°.
3
4
60º
4
hinges as far as they can go into the
two recesses at the bottom of the
oven on the left and the right.
point of resistance and then open it
as far as possible.
hinges.
WARNING!
Risk of electric shock.
The lamp can be hot.
cavity.
access to the lamp.
the cover.
and the seal.
230 V, 40 W, 300 °C heat resistant
lamp.
Tighten the screws.
ENGLISH
39
5
Advertisement
Table of Contents
