John Louis Home JLH-525 Assembly Instructions Manual page 5

STEP 3 - Installing Top Shelf
It is recommended to install hardware into wall studs. Typically 16 in. on
center. Use 50 lb. wall anchors provided if no stud is present.
Space shelf mounting L-clip hardware equidistant in the following manner:
• 4-5 L-clip hardware per 6 ft. shelf span
• 3-4 L-clip hardware per 4 ft. shelf span
• 2 L-clip hardware per 2 ft. shelf span
1. Center the top screw hole of the shelf mounting L-clip hardware with the
level line & mark all hole locations.
2. Secure L-clip to wall using #8 1 1/2 in. screws at hole locations (Use wall
anchors provided if no stud is present).
3. Repeat for all L-clips at top shelf height location.
4. Place Shelf End hardware onto 6 ft. shelf end at side wall location.
5. Place shelf onto shelf mounting hardware.
6. Level shelf.
7. Mark a level line on the side wall at the bottom and side of hardware.
8. Remove shelf & place shelf end hardware at lines and mark screw hole
locations.
9. Secure shelf end hardware to wall using #8 1 1/2 in. screws. Use supplied
wall anchor at marked location if no stud is present.
10. Place shelf into shelf end hardware & onto L-clip hardware.
11. Secure shelf to hardware using #4 3/4 in. screws at all hardware locations.
STEP 4 - Installing Shelf Tower
1. Mark a line on the wall at the center of the last slat on the top shelf.
2. Measure down 72 in. & mark location.
3. Mark a plumb line on the wall down to the 72 in. mark.
4. Measure down & mark the 3 in., 35 in. & 67.5 in locations on the line.
4