geo-FENNEL FL 510HV-G TRACKING User Manual page 40

EN
SLOPE SETTING
Press this button
The curser is below the sign. Change the sign with the buttons
Press the button
Set the slope values with these buttons
next digit.
Press the button
The slope setting of the Y axis is the same as above. After 8 sec. without entry the instrument will
automatically store the values set. For confirmation the instrument will beep. Then, the TILT mode
preparation will start (3 status).
X or Y = -10,000 % up to +10,000 %
X = - or + 10,000 %
Y = - or + 10,000 %
+ 10,000
- 10,000
40
for 2 sec. to enter into the slope mode. The X symbol and „+" will flash.
short to go to the next digit.
again long to select the slope setting of the Y axis.
Single axis
Examples of maximum grade values
or
=> Sum of grade values = 14,000 %
- 10,000 + 10,000
+ 10,000 - 10,000
. Press the button
X and Y ≤ 14,000 %
X = - 6,000 %
Y = - 8,000 %
- 10,000
+ 10,000
.
again to select the
Dual axis
and