Reset Procedure; Pairing Wireless Remote - progressive automations TY-01 User Manual

Reset Procedure

*Please contact our customer service department should you have any questions.*
The handset remote has two different modes which indicate
9
the state of the TV lift
• If the red LED is blinking at 0.5 second intervals, the device is
in RESET mode.
• If the red LED is blinking at 3 second intervals, the device is
in OVERHEAT PROTECTION mode.
The device can go into RESET mode automatically if there is an
error, or the RESET mode needs to be activated manually if the
device is not working as intended.
To Enable RESET mode:
1. To enter the RESET procedure, hold the RESET button on
the wired handset remote until the red LED begins blinking
at 0.5 second intervals.
2. Release the RESET Button once the red LED begins
blinking. This takes approximately 5 seconds.
3. Press and hold the RESET button until the TV lift lowers
completely. Continue holding the RESET button until the
TV lift raises back up about 7mm.
4. Once the red LED stops blinking, the device has completed
the RESET procedure.
Please note, before the RESET procedure is complete, all
buttons will not be functional except for the RESET button on the
wired handset remote.
Warning: The TV lift will move to the zero position when RESET. Be sure there is no obstruction under
Pairing the Wireless Remote
10
Pairing the wireless remote is required before use. There
are two options for pairing the wireless remote:
• Press the UP and DOWN buttons on the wireless remote
while simultaneously pressing the STUDY button on the
wired handset remote for 10 seconds.
• Press the UP and DOWN buttons on the wireless remote
while simultaneously pressing the button on the side of the
control box for 10 seconds.
The TV lift may raise after the remote pairing has been
completed.
Changing Travel Functionality
11
To change the wireless remotes travel function from
Momentary to Non-Momentary, hold the COM button for
approximately 10 seconds.
Basic Troubleshooting
12
If the TV lift is unresponsive, remove power from the control
box and wait for 15 seconds. Reconnect power to the
control box and check that the green LED light on the
control box is on.
the TV set.
8