Stihl MS 461 Manual page 79

Models with heating system
1
: Fit the new gasket (1).
2 1
: Fit the heating element (1) over
the studs (arrows) so that the
thermocouple (2) faces inwards.
1 3
2
The connections with insulating
tubes must be properly seated in
the guides (arrows).
Wire (1) must be positioned
between the guide (2) and the
thermocouple (3).
78
1
3
2
: Fit the baffle plate (1) over the
studs so that the lettering (arrow)
faces outwards.
: Push the knob of grommet (2)
fully into the bore (3).
– Install the throttle rod, b 10.3.1
2
: Push the thin wire (1) and then
the thick wire (2) into the guide
(arrow).
Models without heating
– Install the throttle rod and check
its operation, b 10.3
All versions
– Use STIHL press fluid to make
installation easier, b 15
: Push grommet (1) into holes in
handle housing and make sure it
is properly seated.
– Install the filter base, b 12.3
– Install the air filter, b 12.1
1
– Check operation
– Reassemble all other parts in the
reverse sequence.
MS 461, MS 461-R
1