Philips CEM5000/55 User Manual page 12

Connector Connect to
1 Black wire A metal surface of the car
First connect the black
ground (earth) lead, then
connect the yellow and red
power supply leads.
2 Yellow wire The +12V car battery
which is live at all times.
3 Blue wire Motor/electric antenna
relay control lead/Amplifi er
relay control lead
4 Red wire The +12V power terminal
which is live in the
accessory (ACC) position
of the ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be
sure to connect the black
ground (earth) lead to a
metal surface of the car
fi rst.
5 Green and Left speaker (Rear)
green/black
wires
6 White and Left speaker (Front)
white/black
wires
7 Gray and Right speaker (Front)
gray/black
wires
8 Purple and Right speaker (Rear)
purple/
black wires
3
Connect the supplied standard connector
to the unit.
4
Do the other connections, if applicable.
ANTENNA
Mount in the dashboard
1
If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
FRONT LINE OUT R
FRONT LINE OUT L
REAR LINE OUT L
REAR LINE OUT R
SUB OUT
EN 13