If the car battery is not disconnected,
to avoid short-circuit, ensure that
bare wires do not touch each other.
Remove the two screws on the top of the
Remove the mounting sleeve with the
supplied disassembly tools.
Ensure that car dashboard opening is
within these measurements:
Install the sleeve into the dashboard and
bend the tabs outward to ﬁ x the sleeve.
Skip this step if the unit is not ﬁ xed by sleeve
but by supplied screws.
Place the supplied rubber cushion over
the end of the mounting bolt.
Slide the unit into the dashboard until you
hear a click sound.
Reconnect the negative terminal of the
Attach the front panel
Attach the trim plate to the main unit.
Insert the right side of the panel in the
chassis until it is correctly engaged.
Push the left side of the panel and point
the left hole at the left pillar.
Release the panel to engage the left side.