Troubleshooting - Bostitch FS32C Original Instructions Manual

Tool Operation
1. Put the carton into the required position.
Note: Straighten the center line of the carton to the cover's A center line.
2. Press the step board set down by foot until it stops, then release the step board.
Note: If there is not a carton in position, do not depress the foot lever.

TROUBLESHOOTING

m CAUTION! Pusher spring (constant force spring). Caution must be used when working with the
spring assembly. The spring is wrapped around, but not attached to, a roller. If the spring is extended beyond its
length, the end will come off the roller and the spring will roll up with a snap, with a chance of pinching your
hand. Also, the edges of the spring are very thin and could cut. Care must also be taken to insure no permanent
kinks are put in the spring as this will reduce the spring's force.
m IMPORTANT! Only jam clearance and fastener adjustment should be carried out by non-authorised users.
Illustration
Technical Data:
Please look for the technical data in the table at the front of this manual.
A Length mm.
B Height mm.
C Width mm.
D Weight Kg.
E Noise L
pa
F Noise L
wa
G Noise L
pa
H Vibration m/s
I P max Bar
J P min Bar
Problem
Buckled crown on 19mm
leg staples
Machine operates but
staples do not enter the
board
Clinch too short
Crown collapses
, 1s, d
, 1s, d
, 1s, 1m
2
Cause
Worn driver
Staples jammed in door
Staple leg too short for the
thickness of the work
Staple leg too long for the
thickness of the work
K Air consumption per shot @ 5.6 Bar
L Activation type
M Summer lubricant
N Winter lubricant
O O-ring lubricant
P Fastener Name
Q Dimensions mm.
R Head/crown
S Magazine capacity
T New Driver Length mm.
U Max. Depth Inside Piston mm.
Correction
Replace the driver
Remove the door and
remove jammed staples
Use next longer staple
length
Use next shorter staple
length