Audio Connections - Ricatech RMC430 User Manual

sequential track number. This can be done by pressing the TRACK SPLIT button /
While recording your record, etc., listen for the end of each song. There will usually be a brief silence between songs.
When you are at the end of the song, press the Track Split button. The recording will then go to the next track number
by increments of one. Once the recording has finished, press the
Recording Songs from various sources onto One CD
It is possible to record songs from various sources onto one CD. For example:
· Select "PHONO" mode, play and record the selected tracks on a vinyl record.
· Press "STOP" - the display will read "CLOSE TK".
· Still in PHONO mode, play and record a song on, say, a Cassette.
· Press "STOP" again, the display will show "CLOSE TK".
· The same procedure applies when you wish to add songs from a CD, Aux-in or even Tuner, but remember to press
the Function Button to change to the appropriate CD/AUX" or "TUNER" mode first.
· When you have finally finished recording the various songs on the compilation disc, press the "FINALIZE" button, the
CD will be 'FINALIZED' and can be played in other CD Players.
NOTE: You can record as many tracks as the time on the Compact Disc will allow, so for instance on a disc marked
700MB/80min, this could be up to 70 minutes of music maximum, allowing for gaps between tracks.
Erasing a CD-RW Disc
It is possible to erase all songs on a CD-RW disc and then re-record onto it. Erase procedures are only possible with
CD-RW discs. To erase the contents of the disc, follow the steps below:
1. Press the FUNCTION button /
2. Load a recorded CD-RW into the CD Recorder/Player.
3. Press the STOP button /
4. Press the ERASE button /
and the erasing process will begin. To cancel, please press the STOP button /
first read " F Done " and then " BLANK CD ".
5. The CD is now ready to record on again.
NOTES: Once a CD has been erased, this is permanent and the whole contents previously recorded on the CD cannot
be retrieved. It is not possible to erase or re-record on a CD-R Compact Disc.

AUDIO CONNECTIONS

Line-In Jack on the Front Panel
Press the FUNCTION button /
smaller audio components like MP3 players. The Line-in Jack is located on the front of your unit. This jack needs an
audio cable with 3.5mm diameter mini jack plug for connection (supplied).
1. Plug one end of the cable into the Line-in Jack on the front of your unit.
2. The other end should be plugged into the Audio Output or Headphone Socket on the selected external Player.For
more information on connecting the external Player, see the owner's manual for that unit.
CAUTION: Do not connect anything to the " Aux-in " and " Line-In " Jacks at same time.
to set the unit to CD mode.
to stop playback.
. " ERASE / Y " will appear on the display. Press the PLAY Button /
*
to set the unit to CD/AUX Mode. This connection is especially useful when connecting
.
or buttons to go to the start of each track.
. When finished, the display will
to confirm