Honda 08B23-SJC-100 Installation Instructions Manual page 24

98. Route the interior light harness between the
headliner and the insulator to the interior light
opening, then route the interior light harness out the
headliner opening.
INTERIOR LIGHT
HARNESS
HEADLINER
HEADLINER
OPENING
VEHICLE
FRAME
FRONT
99. Plug the interior light harness 3-pin connector to the
vehicle 3-pin connector.
100. Using isopropyl alcohol on a shop towel, clean the
area where the cushion tape will attach. Using a
scissors, cut one cushion tape in half. Secure the
interior light harness to the headliner with the half
piece of cushion tape.
CUSHION TAPE
Cut in half.
HEADLINER
OPENING
INTERIOR
FRONT
LIGHT
HARNESS
101. Position the 3-pin connectors in the cavity in the
headliner. Connect the interior light harness 3-pin
connector to the rear interior light, then reinstall the
rear interior light.
24 of 28
INSULATOR
INTERIOR LIGHT
OPENING
VEHICLE 3-PIN
CONNECTOR
INTERIOR LIGHT
HARNESS 3-PIN
CONNECTOR
INTERIOR LIGHT
OPENING
3-PIN
CONNECTORS
HEADLINER
820526A
102. Using isopropyl alcohol on a shop towel, clean the
areas where the cushion tapes will attach. Using a
scissors, cut three cushion tapes in half. Secure DIN
cable "A" to the headliner with the six half pieces of
cushion tape.
3 CUSHION TAPES
Cut in half.
FRONT
103. Using isopropyl alcohol on a shop towel, clean the
areas where the EPT sealers will attach. Using a
scissors, cut three EPT sealers in half. Attach six half
pieces of EPT sealer to the monitor bracket in the
areas shown. Cut off the excess EPT sealer.
Cut off the
excess.
AII 50347 (1308))
HEADLINER
OPENING
DIN CABLE "A"
3 EPT SEALERS
Cut in half.
Cut off the
excess.
MONITOR
BRACKET
Cut off the
excess.
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
CUSHION
TAPES
820527B
Cut off the
excess.
820528A