Advertisement
41. Using a felt-tip pen, mark the headliner along the
outer edge of the template as shown. Remove the
template, and extend the lines to the marks you
made on the headliner.
HEADLINER
FELT-TIP PEN
FRONT
42. Using a utility knife, cut out the marked area of the
headliner, then cut out the insulator as shown.
UTILITY
KNIFE
FRONT
12 of 28
Extend the lines
to the marks.
OUTER
EDGE
TEMPLATE
FELT-TIP PEN
HEADLINER
MARK
INSULATOR
Cut out.
HEADLINER
Cut out.
43. Route DIN cable "A" between the headliner and the
insulator to the headliner opening made in step 42.
DIN CABLE "A"
TERMINAL
FRONT
44. Pull out the end of DIN cable "A" to the length shown.
45. Route the yellow label end of DIN cable "A" along the
vehicle harness, and attach DIN cable "A" to the
vehicle harness with one loosely secured wire tie.
EPT SEALER
820420AB
Cut in half.
YELLOW LABEL
46. Using scissors, cut one EPT sealer in half. Wrap one
EPT sealer half around DIN cable "A" in the area
shown.
820421AB
AII 50347 (1308))
HEADLINER
OPENING
250 mm
DIN CABLE "A"
YELLOW LABEL
WIRE TIE
Loosely secure.
VEHICLE
CLIP
VEHICLE
HARNESS
350 mm
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
820422AB
DIN CABLE "A"
820423AB
Advertisement
