Table of Contents
Advertisement
The InteliGen module contains the following three menu screens:
• Measurement
• Adjustment
• History
Can be selected using the following button:
To display the different instruments on each screen menu, press
(16).
The Measurement screen displays the parameters measured by the Engine; if the
Engine uses an electronic management system, many additional parameters can be
displayed. In addition to these parameters, measurements can be displayed for fuel
level, oil pressure, current, voltage, frequency, run hours and battery charge level.
The Adjustment menu screen displays the adjustment parameters already
configured; it is not necessary to edit any of these.
The History screen menu displays the log of alarms that have occurred in the
generator unit. It also logs the opening and closing of the Mains circuit breaker as
well as the starting and shutting down of the generator unit.
STARTUP:
Press the START button
Generator voltage is within the established limits, the LED indicator
lit. Next press the GCB ON/OFF button
directly to the Electrical Generator. To stop the unit, press STOP
LOAD TEST MODE (MANUAL):
This operating Mode is used to allow the Electrical Generator to check the state of the
Mains Power or to disconnect from the Mains when an imminent mains failure is
detected. When this operating Mode is selected, the unit starts up at no load. To
USERS MANUAL
RENTAL SERIES ELECTRICAL GENERATOR
(5) to start up the Electrical Generator. When the
(18).
(10). The loads will be transferred
(17) and
(7) will be
(6).
Page 48 of 62
Advertisement
Table of Contents
