Table of Contents
Advertisement
ALARM LED:
EDITING THE CURRENT DATE AND TIME:
The date and time are adjustable. When the battery is disconnected, the date and
time are frozen; when the battery is reconnected, the date and time shown will be
from the time the battery was disconnected.
The date and time reflected in the Event Log will be taken from the configuration
according to the following steps:
Press
(1) and
Press
(3) until the Date and Time screen appears.
When Date and Time screen appears, press the
start to flash. Press
Press the
(10) button to confirm the value entered. The hour will begin to flash.
Press
(3) or
USERS MANUAL
RENTAL SERIES ELECTRICAL GENERATOR
(11) simultaneously, then enter the correct PIN number.
(3) or
(2) to adjust to the desired setting.
(2) again to adjust to the desired setting.
Remote start on load
Overload pre-alarm
Common alarms
Common shutdown
button (4). The minutes will
Page 44 of 62
Advertisement
Table of Contents
