Section 3: Operation; Prestart Checklist; Starting The Unit - Generac Mobile MLG15 Owner's Manual

Section 3: Operation

Prestart Checklist

Before starting the unit, all items in the prestart checklist
must be completed.
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Verify all maintenance procedures are up to date.
•
For more information, see
and Basic Maintenance
Verify the unit is level.
•
Verify there is no water inside, on, or near the unit.
•
Dry if needed.
For grounding requirements, follow any local, state,
•
or National Electrical Code (NEC) guidelines.
Verify the key switch is OFF (O).
•
Verify all circuit breakers are OFF (O).
•
Inspect all electrical cords; repair or replace any
•
that are cut, worn, or bare.
Verify oil, coolant, and fuel levels are correct, per
•
the engine manufacturer manual.
Verify battery connections are secure.
•
Turn the battery disconnect switch ON, if equipped.
•
Inspect the engine fan belt tension and condition.
•
Inspect the engine fan guard.
•
Inspect the engine exhaust system for loose or
•
rusted components.
Verify the radiator and surrounding shroud are
•
clear of debris.
Verify all covers are in place and secure.
•
Verify the emergency stop switch is pulled out.
•
Owner's Manual for Mobile Generator
(000100a)
General Maintenance
Schedule.

Starting the Unit

DANGER
Asphyxiation. Running engines produce
carbon monoxide, a colorless, odorless,
poisonous gas. Carbon monoxide, if not
avoided, will result in death or serious injury.
Equipment Damage. Do not continuously crank
engine for more than ten seconds. Doing so will lead
to overdischarge of batteries and starter seizure.
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to bleed the fuel lines.
See the engine operator's manual supplied with the unit.
Verify the main circuit breaker and individual circuit
1.
breakers for each of the receptacles are OFF (O).
NOTE: When the circuit breaker indicator light
(Figure 2-4) is illuminated, the main circuit breaker must
be turned to OFF (O).
See Figure 3-1. Turn the key on the key switch to
2.
GLOW PLUG and hold for five seconds, or until the
glow plug indicator turns red.
GLOW
PLUG
Figure 3-1. Activate Glow Plug
NOTE: For glow plug interval in cold weather conditions,
see engine manual.
CAUTION
(000230)
003552
(000103)
15