Silvercrest SSRA1 Manual page 9

in a particular installation. If this
product causes harmful interfer-
ence to radio or television recep-
tion, which can be determined
by turning the product off and on,
the user is encouraged to try and
correct the interference by one or
more of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation between
the equipment and receiver.
• Connect the product into an
outlet on a circuit different
from that to which the receiver
is connected.
• Consult the dealer or an expe-
rienced radio / TV technician
for help.
This product complies with part
15 of the FCC Rules. Operation
is subject to the following two
conditions:
(1) This product may not cause
harmful interference, and
(2) this product must accept any
interference received, including
interference that may cause un-
desired operation.
309029_1901__silv_Saugroboter SSRA1_content_US.indd 9
observe the following warn-
ings can result in injuries or
property damage.
Only use the original recharge-
able battery and charging dock
supplied by the manufacturer.
2
Never use primary batteries.
For more information about the
battery, please see chapter
"Technical data".
Do not use the product if it can't
work properly due to
- falls,
- damages,
- ingress water,
- outdoor use.
Have the product repaired by
the manufacturer or its customer
service department.
Keep hair, clothing and fingers
away from the openings or op-
erating parts of the product.
Regularly clean the cliff sensors.
If the floor sensors are dirty, the
product may fall down stairs or
landings.
When using the product, inform
any others in the room so nobody
steps on or trips over the product.
Discontinue using the product if
the plastic parts are cracked or
deformed. Always replace dam-
aged parts with genuine spare
parts.
Failure to
US-EN 9
11.09.19 08:26