Silvercrest SSRA1 Manual page 30

Problem
The robot vacuum cleaner
does not charge.
The robot vacuum cleaner
gets stuck while cleaning.
The robot vacuum cleaner
returns to the charging
dock to recharge be-
2
fore it is done cleaning.
The robot vacuum cleaner
does not clean according
to the cleaning schedule.
The remote control is not
working (the effective
range is 16.40 ft (5 m).
30 US-EN
309029_1901__silv_Saugroboter SSRA1_content_US.indd 30
Reason
The robot vacuum cleaner is not making
good contact with the charging contacts
on the charging dock
3
The charging dock is turned off and
2
the robot vacuum cleaner is turned on,
draining the battery.
The robot vacuum cleaner is obstructed
by cables, curtains or rugs on the floor.
Low battery, the robot vacuum cleaner
automatically returns to the dock to
recharge.
Wood floors, tiling and different floor
levels, cleaning speed and time of the
robot vacuum cleaner vary.
The robot vacuum cleaner is not
turned on.
Battery low
The robot vacuum cleaner is clogged.
Remote control batteries low.
The robot vacuum cleaner is turned
off / robot vacuum cleaner battery low.
The infrared sensor on the remote con-
trol or the receiver on the robot vacuum
cleaner are dirty and unable to transmit
or receive signals.
An object near the robot vacuum cleaner
is interfering with the infrared rays.
Solution
Make sure there is good contact
between the robot vacuum cleaner
. and the charging contacts
2
the charging dock
We recommend continuous
charging when the robot vacuum
cleaner is not in use to ensure it
has enough power for the next
cleaning.
The robot vacuum cleaner auto-
matically tries to find different
solutions. If it is unable to find a
solution, you will need to intervene.
Charge the robot vacuum cleaner.
The cleaning times of the robot
vacuum cleaner vary based on
the complexity of the room, dirt
level and cleaning mode.
Turn on the power switch
(Position "–").
If the robot vacuum cleaner is in
standby, make sure it is charged
so it will always have enough
power to clean.
Turn the product off and clean the
dust bin
17
Replace the batteries with new bat-
teries and install these properly.
Verify the power switch
(Position "–") and the robot vac-
uum cleaner has enough battery
power.
Clean the infrared sensor or the
receiver on the robot vacuum
cleaner with a cotton cloth.
Avoid using the remote control
near other infrared devices.
on
3
.
2
9
and other parts.
is on
9
11.09.19 08:26