11. CONNECTING THE ROOM THERMOSTAT
The system must be fitted with an ambient thermostat for controlling indoor temperature.
To connect this device, proceed as follows:
•
Access the electrical components as described in paragraph 9.1.
•
Remove the jumper on terminals (1) and (2) ft the main terminal block (see wiring diagrams in § 10).
•
Thread the two-wire cable through the grommets of the electrical box and connect it to these two terminals using a
harmonised cable "HAR H05 VV-F" 2 x 2 mm
INSTALLATION AND OPERATING MANUAL
10. WIRING DIAGRAM
21
11
24
14
A2
A1
22
12
with a maximum diameter of 8 mm.
2
45
7224230.02 - en