9. WIRING DIAGRAMS
10. CONNECTING THE AMBIENT THERMOSTAT
The system must be fitted with an ambient thermostat in order to control room temperature.
To connect this device, proceed as follows:
• Access the electrical components as described in section 8.
• Remove the jumper on terminals (1) and (2) of the main terminal block (see wiring diagram in § 9).
• Thread the two-wire cable through the grommets of the electrical box and connect it to these two terminals using a
harmonised cable "HAR H05 VV-F" 2 x 0.75 mm
with a maximum diameter of 8 mm.
2
In the cooling mode, an ambient thermostat set for summer operation must be used. Select summer operation when the
ambient temperature rises, the thermostat must close the contact to allow chilled water to enter the satellite.
INSTALLATION AND OPERATING MANUAL
7213763.01 - en
44