Advertisement
Installation
Installing a Wall-Mounted Master Control in a newly installed wallbox.
Check off Steps as completed.
Step 1
Turn power off at circuit breaker panel or remove
fuse from fusebox.
Important Wiring Information
When making wire connections, follow the recommended strip lengths and combinations for the
supplied wire connectors. Note: Wire connectors provided are suitable for copper wire only.
For aluminum wire, consult an electrician.
Small:
Strip insulation 3/8" for 14 AWG wire
Strip insulation 1/2" for 16 or 18 AWG wire
Use to join one 14 AWG supply wire with one 16 or
18 AWG control wire.
Large:
Strip insulation 1/2" for 10, 12 or 14 AWG wire
Strip insulation 5/8" for 16 or 18 AWG wire
Use to join one or two 12 or 14 AWG supply wires
Small
with one 10, 12, 14, 16, or 18 AWG control wire.
Step 2
Wire the Control.
Using the wire connectors provided:
• Connect the master control green
ground wire to the green or bare
copper ground wire in the wallbox.
If there is no ground wire in your
wallbox, consult an electrician.
• Connect the black control wire to
the HOT wire coming from the
breaker panel.
• Connect the white control wire to
the NEUTRAL wire coming from the
Green
breaker panel.
ground wire.
Wiring Diagram
Master Control
Black
Hot
120/127V
50/60Hz
White
Neutral
Green
Ground
Step 3
Attach wallplate adapter. Mount and align control.
Snap on Claro
Tighten screws
until snug.
Twist wire
connector tight.
Step 4
Be sure no bare
Turn power ON.
wire is exposed.
Large
Neutral
White
Black
Hot
Bare copper
or green
ground wire.
wallplate (purchased separately).
®
Snap on wallplate.
Align Control.
Operation of the Master Control
Morning
Den
Brkfast
Dining
Dinner
Rec Rm
Relax
Family
Goodnite
M Bedrm
ALL ON
ALL OFF
Raise
Brighten ROOM or SCENE lights*.
Lower
Dim ROOM or SCENE lights*.
* To select the ROOM or SCENE button you
wish to Raise or Lower, quickly tap that button
twice.
NOTE: Master Controls will not operate until they have been
programmed.
For detailed instructions on programming your Master
Control, refer to the RadioRA
Setup Guide that is included
®
with an RF Signal Repeater.
Button
Turns lights on/off.
LEDs
Glow when associated
Room or Scene lights
are on.
Labels
Printed and blank
labels provided.
All On
All lights on.
All Off
All lights off.
Advertisement
