Chelsio T5 Installation And User Manual page 43

Chapter 5. Software/Driver Configuration and Fine-tuning
-F
-g
-G <var=const>
Chelsio T5 iSCSI PDU Offload Target with SCST support for Linux
target=<name>
-k lun=<value>
iscsictl -c target=iqn.com.cc.it1
Iscsictl -c target=iqn.com.cc.target1 -k
TargetAlias
The <name> parameter can also be specified
as one or more parameter on the same
command line, separated by a comma,
target=<name1>, <name2>, ... ,<nameN>
The target=<name> parameter(s) are optional
and if not specified all active Chelsio iSCSI
targets(s) configuration(s) will be displayed.
If target=ALL is specified or no parameters
are specified the output will be abbreviated.
Specify specific targets to get detailed
configuration data.
If the target=<name> option is specified, the -k
<key> option can optionally be specified along
with this option to display only the selected
entity parameter setting.
Example:
iscsictl -c target=iqn.com.cc.target1 -k
HeaderDigest
Flush the cached data to the target disk(s).
target=<name> parameter:
Where name is the name of the target to be
flushed. name can be one or more string of
names, separated by a comma,
<name1[,name2,...,nameN] | ALL>
A name of ALL will cause all the target data to
be flushed. ALL is a reserved string that must
be uppercase.
The target=name parameter is optional. If no
target=name parameter is specified, it is the
same as specifying target=ALL.
The -k lun=<value> option is optional. It can be
used to further specify a particular lun to be
flushed.
Example:
To flush all the targets in the system:
iscsictl -F
To flush a particular target:
iscsictl -F target=iqn.com.cc.it1
To flush only the lun 0 of a particular target:
iscsictl -F target=iqn.com.cc.it1 -k lun=0
Display the Chelsio iSCSI Global Entity
Settings.
Set the Chelsio iSCSI Global Entity Settings.
var=const parameter:
Where var=const can be any key listed under
Chelsio Global Entity Settings.
43