Chelsio T5 Installation And User Manual page 31

Iscsi pdu offload target with scst support for linux
Table of Contents

Advertisement

Chapter 5. Software/Driver Configuration and Fine-tuning
# flag "SYNC" means for every write request, sync to the disk before
# send back the response
# flag "DIF" means end to end (initiator to target backend) pi
# protection is enabled.
# flag "DIX" means target HBA to target backend pi protection is
# enabled. All luns on a node should have same the value
# (DIF or DIX) for protection.
# lun 0: a Pass-Through SCST disk device
TargetDevice=/dev/sdb,SCST
# lun 1: a FILEIO SCST device
TargetDevice=/tmp/file1,SCST
# lun 2: a BLOCKIO SCST device
TargetDevice=/dev/vg1/lv1,SCST
# lun 3: a ramdisk, with default size of 16MB
#TargetDevice=ramdisk1,MEM
# lun 4: a ramdisk, with a minimum size of 16MB, and no actual read or
#
write of data.
#TargetDevice=ramdisk2,MEM,NULLRW,size=16MB
# Target Portal group information, adjust to your system specifc
PortalGroup=1@192.168.1.1:3260
PortalGroup=2@192.168.1.2:3260
#
#Access Control List settings
#
#
ACL_Enable=[Yes|No]
#
ACL=[iname=<initiator name>;][;<sip=src ip>][;<dip=dst ip>]
#
#
#ACL_Enable=Yes
# initiator iqn.2004-08.com.chelsio.test1 is allowed r/w access on all
Chelsio T5 iSCSI PDU Offload Target with SCST support for Linux
[;<lun=ALL:R|RW>]
31

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T5 and is the answer not in the manual?

Table of Contents