Chelsio T5 Installation And User Manual page 16

Chapter 4. Software/Driver Loading
iv. Apply LUN configuration to SCST:
[root@host~]# scstadmin -force -clear_config /etc/chelsio-iscsi/scst.conf
[root@host~]# scstadmin –config /etc/chelsio-iscsi/scst.conf
Auto-start iSCSI service at boot-up
chelsio-target
The
/etc/sysconfig/chiscsi
script are installed at
To auto-start the iSCSI target service at a certain runlevel, e.g. runlevel 3,
used on Red Hat and Novell / SuSE based systems as follows:
[root@host~]# chkconfig –-level 3 chelsio-target on
The chelsio-target
loads the driver, and starts all the targets configured by default. It can also be used to stop the
targets, and restart/reload configuration.

For the script to execute properly, make sure the following flag is set on
Note
all kernel.org kernels.
# CONFIG_MODULE_FORCE_LOAD=y

The script will not work on Ubuntu platforms and also when SCST
configuration is used.
Chelsio T5 iSCSI PDU Offload Target with SCST support for Linux
service scripts are installed to
service scripts do basic checks before starting the iSCSI target service,
/etc/init.d
and the parameters for the
. The script is installed as a system service.
chkconfig can be
16