Chelsio T5 Installation And User Manual page 22

Chapter 5. Software/Driver Configuration and Fine-tuning
Table of Chelsio Global Entity Settings
Key
iscsi_auth_order
DISC_AuthMethod
DISC_Auth_CHAP_Policy
DISC_Auth_CHAP_Target
DISC_Auth_CHAP_Initiator
iscsi_chelsio_ini_idstr
Chelsio T5 iSCSI PDU Offload Target with SCST support for Linux
Valid Default
Values Value
"ACL"
"CHAP"
"CHAP"
"CHAP"
None
"NONE"
"Oneway"
"Oneway"
"Mutual"
"<user
id>"
:"<secret>
"
"<user
id>"
:"<secret>
"
a string of
maximum of
"cxgb4i"
255
characters
Multiple
Description
Values
Authorization order for login
verification on the target. Valid
only when a target's
ACL_Enable=Yes
No
ACL: ACL first then CHAP
CHAP: CHAP first then ACL
Applies to Target(s) Only
To choose an authentication
No
method for discovery phase.
Oneway or Mutual (two-way)
No
CHAP
CHAP user id and secret for the
target.
<user id> must be less than
256 characters.
are not allowed.
<secret> must be between 6
and 255 characters. Commas
"," are not allowed.
Yes
The target user id and secret
are used by the initiator to
authenticate the target while
doing mutual chap.
NOTE: The double quotes are
required as part of the format.
CHAP user id and secret for the
initiator.
<user id> must be less than
256 characters.
are not allowed.
<secret> must be between 6
and 255 characters. Commas
Yes
"," are not allowed.
The initiator user id and secret
are used by the target to
authenticate the initiator.
NOTE: The double quotes are
required as part of the format.
To enable
optimization
Adapters and drivers are used
at both ends (initiator and
target) systems.
No
Make sure the initiator name
contain the substring set in
iscsi_chelsio_ini_idstr when
using Chelsio iscsi initiator
Commas ","
Commas ","
additional
when Chelsio
22