Changing Setting Values; Resetting To Default; Fs Switching - FOR-A FA-10RU Operation Manual

4-3-5. Changing Setting Values

Once the desired menu is displayed, use the controls (F1-F4) to change the setting values.
MU SEL GENLOCK FAN ALARM
POW ER
LOCK
ON
FREEZE DC POWER
FS SEL
FS LINK
TEST SIGNAL
OFF
BY-PASS
EV ENT
- - - V I D E O P R O C E S S A M P L I F I E R - - -
F 1 V i d e o L e v e l : 1 0 0 . 0 %
F 2 C h r o m a L e v e l : 1 0 0 . 0 %
F 3 B l a c k L e v e l :
F 4 H u e
Assigned control
Parameters
F1 - F4.
To display the menu shown above, press the 1 PROC/EMB button while the VIDEO/AUDIO
button is lit green (VIDEO menu mode).
Use the up/down single-arrow buttons to select a menu item (F1 to F4 flashing). If the LED
around a control knob (F1 to F4) is lit, the corresponding value can be changed.
To go to other menus assigned to the menu button, press the double down-arrow button. To
return to the previous menu, press the double up-arrow button.

4-3-6. Resetting to Default

Each control button (F1-F4) has a UNITY button.
UNITY button lights are goes off when setting values are not default.
Pressing a UNITY button while the light is off returns the corresponding setting value to the
default value. Then the light turns on. Pressing the button again returns the value to the
previous value before resetting to the default value.
Press UNITY button to reset
the value. The indicator lights
up orange.

4-3-7. FS Switching

Ineffective when connecting to USF-1043FS modules.
DISPLAY AREA
F1
UN ITY
F A - 1 0 R U
R E M O T E C O N T R O L U N I T
Menu title
0 . 0 %
: 0 . 0 %
R E M O T E C O N T R O L U N I T
Settings
F1 F2
UNITY UNITY
20
PR OC
1 2
EMB
INP UT
5 6
F4 A ES
F2 F3
UNITY UNITY UN ITY
A NC
9 10 SYSTEM
ANA LOG
Control
F1-F4
Menu number
P 1 3 0 0
F A - 1 0 R U
F4
F3
UNITY UNITY
CC CL IP BY-P ASS
3 4
SE TUP DWN MIX MAP PING
CLN SW OUT PUT
7 8 OPT ION
GAIN DE LAY
VID EO
0 STA TUS
AU DIO