Main Features; Installation And Adjustment - TdA DKC301DC Installation And User Manual

DKC301DC SLIDING GATE OPERATOR INSTALLATION AND USER'S MANUAL

3. Main Features


For Sliding Gate weighing up to 500KG.

DC 24V Operating Voltage for Safety and Convenience.

Encode Limit Inside, Easy to Set and Adjustment.

Soft-start & Soft-stop, Running Smoothly.

Auto-reverse when Obstruction.

Auto-Close Mode Available.

Pedestrian Mode Available.

Available for infrared Photocells, Alarm Lamps. etc.

Manual key release design for emergency purposes.

With Backup Battery.

Quality Cast Aluminum Body.

4. Installation and Adjustment

The DKC301DC rack-driven gate operator operates by forcing a drive rack past a drive gear. The entire
configuration is shown in Fig.1. The gate operator must be installed on the inside of the gate.
Gate preparation
Make sure the gate is installed properly and slides smoothly before installing the sliding gate operator.
The gate must be plumb, level, and move freely.
Conduit
In order to protect the wires, use PVC conduit for wires, conduit must be set into the concrete when it is
poured. Wires within the conduit shall be located or protected so that no damage can result from
contact with any rough or sharp part.
Concrete Pad
The base unit of the gate operator requires a concrete pad in order to maintain proper stability. The
concrete pad should be approximately 300mm x 200mm x 200mm deep in order to provide for
adequate operation. The pad should be 70mm above finish grade. Be sure to locate the pad so that it
will not interfere with the gate.
240
300
278
Fig.1 Gate operator
162
4