Programming; Setting Open And Close Position - TdA DKC301DC Installation And User Manual

DKC301DC SLIDING GATE OPERATOR INSTALLATION AND USER'S MANUAL
Encoder
Reserve for
mechanical
limit switch
Pedestrian Mode Key
Keypad
Open button
Close button
Stop button
Com

6. Programming

Short the infrared terminal block(see Fig.5 terminal 4 and 5) if the gate only runs in open direction.

Setting Open and Close Position

1. Press and hold SET (see Fig.5 control board) until '1' indicated on the LED display.
2. Press and hold OPEN to set open position, release the button until the gate has reached the
desired position. (You also can press CLOSE to close the gate, OPEN and CLOSE can be used
to adjust the door position.)
3. Press the SET to confirm the open position, and '2' will be displayed.
4. Press and hold CLOSE to set close position, release the button until the gate has reached the
L
POWER SUPPLY
N
AC240V
Fig.5 Control board Diagrams
7
Alarm lamp -
Alarm lamp +
Motor +
Motor -
+24V output
Infrared
Com
Power +
Input
Power -
Battery -
Battery +