The voltage of the 3V adapter must match with the local
voltage. The 3.5 mm adapter plug's 1.3 mm centre pin must
also be connected to the minus pole -.
• Connect the mains adapter to the set's DC 3V socket.
• Always disconnect the mains adapter if you are not using it.
• Open battery door and insert two alkaline batteries, type R6,
UM3 or AA as indicated.
batteries gives up to 18 hours of cassette playback.
• Remove the batteries from the set if they are exhausted or
not to be used for a long time.
™ When the batteries are running low,
briefly in the display and you should insert new batteries.
If the radio is on, it will automatically switch off.
™ It may be necessary to reprogramme your preset stations.
Use of Philips POWER LIFE
The memory protection acts as a backup should there be a
power failure or interruption.
When changing batteries or power supply, the time setting,
presets and the last station listened to are retained for
approximately 2 minutes. This allows you to change batteries
or power supply without having to set your stored data all over