Power Supply - Philips MAGNAVOX AZ2905 Owner's Manual

CONTROLS
POWER SUPPLY
Batteries
Set(R20,UM1 orD-cells):
• Open the battery compartment of the set and insert six batteries,
type R20, UMt or D-cells (preferably alkaline).
Remote control (R03, UM4 or AAA-cells):
• Open the battery compartment of the remote control and insert
two batteries, type R03, UM4 or AAA-cells (preferably alkaline).
• Remove the batteries if they are empty or the set is not to be
used fora long time.
All kinds of batteries contain chemical substances
therefore they should be disposed of properly.
l-IU JU Til
pJL
j
II
MM
Mains
1 Check if the mains voltage as shown on the type plate
corresponds to your local mains voltage. If it does not, consult
your dealer or service organisation. The type plate is located
at the base of the set.
2 Connect the mains cable to the AC MAINS inlet and the wall
socket. The AC power supply is switched on. The mains cable
is inside the battery compartment.
The battery supply is switched off when the set is connected to the
mains. To change over to battery supply, pull out the plug from the
unit's AC MAINS socket.
To disconnect the set from the mains completely, withdraw the
mains plug from the wall outlet.
8