Dolphin BC5083-01 User Manual page 23

TAP INSTALLATION
5. After you have connected the power
source (Battery or Transformer) wait 15
seconds in order to allow the system to set
the ideal sensor range. As an indication that
the self adjusting is taking place, a red light
in the sensor eye will flash continuously. The
solenoid valve will be opened and closed
for 1 second as an indication that the ideal
sensor range was set and the product is
ready for use.
STEP 3 - CONNECTING THE WATER SUPPLY
1. Turn on the central water supply.
2. Check for leaks.
3. Assemble the wall cover panel by screwing the four screws.
Note: This tap includes a special aerator that allows you to adjust the water stream
direction on site in order to prevent water splashing. To change the angle of the
water stream, simply move the adjustable tilting plate by
pressing it smoothly.
4. If the automatically adjusted sensor range is not
satisfactory, please refer to the section entitled "Settings
adjustment".
DBL400 / DBL425 / DBXL450 / DBXL475 Series | Dolphin Blue | 13