Dolphin BC5083-01 User Manual page 16

PRE INSTALLATION
CHECK CONTENTS
› Separate all parts from the packaging and check you have each part according to the
pack contents section, pages 4-6. Pay attention to the variations of the different
models.
› Make sure all parts are accounted for before discarding any packaging material.
› If any parts are missing, do not attempt to install your electronic tap.
Please call 0800 0723 404 immediately to notify us.
WARNING
› To avoid reflection problems keep a distance of
more than 300 mm. between the sink and the
spout.
› This tap model, with an infrared sensor pointing
down, is not intended to be used together with
a sink of a reflective material such as stainless
steel.
› If a sink strainer is straight below the tap sensor,
use a strainer with a non reflective finish (do
not use a chrome plated one).
PREPARATION FOR INSTALLATION
› Flush water supply lines thoroughly before installing the tap.
› Do not allow dirt, Teflon tape or metal particles to enter the tap.
› Shut off water supply.
Important All plumbing is to be installed in accordance with applicable codes and
regulations.
6 | Dolphin Blue | DBL400 / DBL425 / DBXL450 / DBXL475 Series