Dolphin BC5083-01 User Manual page 21

TAP INSTALLATION
INSTALLATION INSTRUCTIONS FOR DB450 AND DB 475
STEP 1 – INSTALLING THE TAP
1. Shut off the water supply
2. Cut an adequate opening in the wall
according to the dimensions of the
tap box, the cables sleeve, the rigid
pipe and the tap base with the
support (at the place where you
want to install the spout).
3. Cut two small holes for the tap base
support and drive the anchors in.
4. Insert the tap box through the wall. Connect the water supply pipe to the nipple at
the bottom of the tap box.
5. Mount the tap base with the support through the wall opening, and secure the base
support to the two small holes using 2 screws.
Important: The tap base should be installed so that the outside surface of the
finished wall falls between the minimum and maximum lines marked at the base.
6. Assemble the rigid pipe from the nipple at the box to the inlet at the tap base.
7. Pull the wires of the power supply (transformer/battery) and sensor cable out of the
tap base.
8. Lead the wires through the cable sleeve.
9. Connect the electronic unit's connector coming from the tap base to the solenoid's
connector.
DBL400 / DBL425 / DBXL450 / DBXL475 Series | Dolphin Blue | 11