Table of Contents
Advertisement
OE
with Keyless Ride
Switch off the ignition.
Press button 1 on the radio-
operated key twice.
Activation takes approximately
30 seconds to complete.
Turn indicators flash twice.
Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is active.
Press button 1 again on the
radio-operated key during the
activation phase to deactiv-
ate the motion sensor (e.g. to
transport the motorcycle by
train when the severe move-
ments may activate the alarm).
Turn indicators flash three
times.
Confirmation tone sounds three
times (if programmed).
Motion sensor has been deac-
tivated.
Alarm signal
A DWA alarm can be triggered
by:
motion sensor
an attempt to use an unauthor-
ised vehicle key to switch on
the ignition
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash)
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
4
85
z
Advertisement
Table of Contents
