Brakes - BMW R 1200GS Rider's Manual

See the section "Engineering
6
details" for more information on
the Pro shift assistant.
112
Shift assistant Pro (

Brakes

How can stopping
distance be minimised?
Each time the brakes are applied,
z a load distribution shift takes
place with the load shifting for-
ward from the rear to the front
wheel. The sharper the motor-
cycle decelerates, the more load
is shifted to the front wheel. The
higher the wheel load, the more
braking force can be transmitted
without the wheel locking.
To optimise stopping distance,
apply the front brakes rapidly and
keep on increasing the force you
apply to the brake lever. This
makes the best possible use of
the dynamic increase in load at
the front wheel. Remember to
pull the clutch at the same time.
In the "panic braking situations"
that are trained so frequently
braking force is applied as rap-
idly as possible and with the
132)
rider's full force applied to the
brake levers; under these circum-
stances the dynamic shift in load
distribution cannot keep pace
with the increase in deceleration
and the tyres cannot transmit the
full braking force to the surface
of the road.
BMW Motorrad Integral ABS pre-
vents the front wheel from lock-
ing up.
Hazard braking
with riding modes Pro
If you brake sharply from a speed
in excess of 50 km/h, the brake
light flashes rapidly as an addi-
tional warning for road users be-
hind you.
The hazard warning lights sys-
tem switches on if you brake to
below 15 km/h in this process.
The hazard warning lights system
automatically switches off again
from a speed of 20 km/h.
Descending mountain
passes
WARNING
Braking only with the rear
brake on mountain descents
Brake fade, destruction of the
brakes due to overheating
Use both front and rear brakes,
and make use of the engine's
braking effect as well.
Wet and dirty brakes
OE
Wetness and dirt on the brake
discs and the brake pads dimin-
ish braking efficiency.
Delayed braking action or poor
braking efficiency must be
reckoned with in the following
situations: