Important Maintenance Instruction - netvox R718N1 User Manual

4. The single-phase current detector (R718N1) takes 15 seconds to
sample the current, that is, the device starts sampling 15 minutes before
the arrival of Min Time. If the current value of the sample is relatively
compared with the current value reported last time, it exceeds the set
value (default value 100mA), when the Min Time is reached, the current
value of the current sample is immediately reported. If the current
change does not exceed the default value, the data will be reported
regularly according to Max Time.
Short press the [Key] of the device to start sampling data and report the
data about 15 seconds after pressing the key.
Note: Min Time cannot be set less than 30 seconds.
Max Time must be set greater than Min Time.

8. Important Maintenance Instruction

Your device is a product of superior design and craftsmanship and should be used with care. The following suggestions will help you use the warranty
service effectively.
• Keep the equipment dry. Rain, moisture, and various liquids or moisture may contain minerals that can corrode electronic circuits. In case the
device is wet, please dry it completely.
• Do not use or store in dusty or dirty areas. This can damage its detachable parts and electronic components.
• Do not store in excessive heat. High temperatures can shorten the life of electronic devices, destroy batteries, and deform or melt some plastic parts.
• Do not store in a cold place. Otherwise, when the temperature rises to normal temperature, moisture will form inside, which will destroy the board.
• Do not throw, knock or shake the device. Rough handling of equipment can destroy internal circuit boards and delicate structures.
• Do not wash with strong chemicals, detergents or strong detergents.
• Do not apply with paint. Smudges can block debris in detachable parts and affect normal operation.
• Do not throw the battery into a fire to prevent the battery from exploding. Damaged batteries may also explode.
All of the above suggestions apply equally to your device, battery and accessories. If any device is not working properly.
Please take it to the nearest authorized service facility for repair.
The single-phase current detector (R718N1) is
suitable for the following scenarios:
 School
 Factory
 The mall
 Office building
 Smart building
Where the electrical data of the equipment needs to
be detected.
7