Mounting Sai Distributors - Weidmuller SAI Active Universal Pro Series Manual

Mounting SAIs
4.2

Mounting SAI distributors

Mounting
To mount the SAI distributor, select a firm and level
surface. Pre-drill the bore holes. Hold the distributor
above the bore holes and fix it in positions with
screws. Please use a spring washer if the SAI dis-
tributor is to be used in an environment where the
loads are subject to increased shock and vibration.
Please refer to Figure Mounting the gate-
way I/O.
PROFIBUS guidelines
Please observe the PROFIBUS guidelines: Installa-
tion Guideline for PROFIBUS-DP/FMS.
Figure 8 Mounting the gateway I/O
24
DANGER!
Isolate the system before connecting the
power supply connector or inserting or
removing jumpers.
Figure 9 Mounting the extension I/O
Torques
Observe the following torques:
M8 connectors
M8 protective cap
M12 connectors
M12 protective cap
Screw for peak window
0.6 Nm
0.4 Nm
0.8 Nm
0.8 Nm
0.5 Nm
5663600000/1.4/09.09