Fisher & Paykel RB2470BRV Installation Manual page 24

Loosening the height adjustment nut
Before installing the top door panel, you must
remove the door magnet from the refrigerator
door to enable you to access and loosen the
height adjustment nut.
Remove the magnet (D) by unscrewing the
6
screws (E) using a crosshead screwdriver.
IMPORTANT!
Keep the sensor magnet to reinstall later.
Loosen the height adjustment nut (F) with
7
a spanner.
IMPORTANT!
Do not remove!
Note: Loosening the nut allows you to easily
turn it from the top using a T-handle hex
key after the door panel has been installed.
Reinstall the sensor magnet to the refrigerator
8
door (G) and then close the door.
IMPORTANT!
Reinstall the door sensor magnet before
● ●
fitting the door panel as this is not possible
once the door panel is installed.
The magnet sensor is installed only on the
● ●
refrigerator door.
22 22
!9 INSTALL TOP DOOR PANEL (CUSTOM)
D
E
E
F
G
Installing the hanging and attachment brackets
Lay the top custom door panel
9
(face down) onto the floor and
place the top hanging bracket on
the door panel. Latch the rulers on
top of the door panel (H).
Align the center line of the top hanging
!0
bracket with the center of the top door panel.
Once aligned, fix the top hanging bracket to
!1
the top door panel with wood screws.
Remove the rulers from the top hanging
!2
bracket and discard.
H