Fisher & Paykel RB2470BRV Installation Manual page 20

IMPORTANT!
Ensure to protect the finish of the Fisher & Paykel Stainless steel door panels.
● ●
Leave the protective film on the panels when hanging and remove the film only when the installation is complete.
● ●
Removing the hanging bracket
Open the refrigerator door and remove the top
1
hanging bracket cover by drawing out upwards.
Remove the two side adjustment
2
nuts (A) on the top hanging bracket
using a spanner, then remove the top
hanging bracket and rulers together.
– Keep the hanging bracket to
reinstall later.
A
Repeat steps – for the freezer door.
1 2
18
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
Refrigerator door
Top hanging
bracket
Refrigerator door
Loosening the height adjustment nut
Before installing the top door panel, you must
remove the door magnet from the refrigerator
door to enable you to access and loosen the
height adjustment nut.
3 Remove the magnet (B) by unscrewing the
screws (C) using a crosshead screwdriver.
IMPORTANT!
Keep the sensor magnet to reinstall later.
Loosen the height adjustment nut (D) with
4
a spanner.
IMPORTANT!
Do not remove!
Note: Loosening the nut allows you to
easily turn it from the top using a hex key
after the door panel has been installed.
Reinstall the sensor magnet to the refrigerator
5
door (E) and then close the door.
IMPORTANT!
Reinstall the door sensor magnet before
● ●
fitting the door panel as this is not possible
once the door panel is installed.
The magnet sensor is installed only on the
● ●
refrigerator door.
B
C
C
D
E