Fisher & Paykel RB2470BRV Installation Manual page 21

Installing the hanging and attachment brackets
6 Remove the rulers (F) from the top hanging
bracket and discard.
Align the screw holes of the top
7
hanging bracket with the screw holes of
the top door panel and fix the bracket
with supplied M5x12 screws (G).
Align the screw holes of the bottom
8
attachment bracket assembly (Bottom
attachment bracket, Side spacer
bracket, Bottom attachment strap) with
the screw holes of the top door panel,
and fix with M5x12 screws (H).
Attaching the door handle
9 Remove the plastic plugs from handle
holes (4x).
Align the handle to the holes and secure
!0
with M5x25 hex screws (I).
Repeat steps 6 – for the door panel
!0
of freezer door.
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
F
G
H
Hanging the door panel
Open the refrigerator door.
!1
Hang the top door panel onto the height
!2
adjustment nuts (J) at the top of the
refrigerator door.
Screw the side adjustment nuts (K) onto
!3
the thread of the height adjustment
nuts to secure the door panel to the
refrigerator door.
– Do not tighten fully to allow
adjustment of the top door panel.
I
Align the bottom attachment
!4
brackets with screw holes at the
bottom of the top door panel.
Fasten with bottom attachment
screws (L).
– Do not tighten fully to
allow adjustment of the
top door panel.
Repeat steps – for the door panel of freezer door.
!1 !4
Note: The magnet sensor is installed only on the refrigerator door.
J
K
L
Bottom view of door
K
19