4.4 Data Report
When the device is turned on, it will immediately send a version package and a cluster report which
includes battery voltage and three-phase current values.
Data will be reported once per hour by default setting.
Maximum time: 3600 seconds
Minimum time: 3600 seconds
Default reportchange:
Battery --- 0x01 (0.1V)
Note:
Data sending cycle is programmed by real configuration.
The interval between two reports must be
Three-phase current detection:
When the key is pressed, a report is sent immediately to return the current three-phase current value.
Or it detects and returns current information when the time configuration is due.
Data report configuration and sending period are as following:
Min. Interval
(Unit:second)
Any
number
between 30~65535
5. Restore to Factory Setting
To restore to factory setting, users need to execute below operations.
1. Press and hold function key for 5 seconds till the green indicator flashes and then release; LED
flashes quickly 20 times.
2. R718N3 is at off mode by default setting after restoring to factory setting.
Note: "Turn off" operation and "Restore to Factory Setting" operation are the same.
Max. Interval
Reportable
(Unit:second)
Change
Any
number
between
Can not be 0.
Min.~65535
Min. Interval.
Current
Reportable Change
Report
per Min. Interval
5
Current
Change <
Change≥
Reportable Change
Report
per Max. Interval