Hussmann RL2W Installation & Operation Manual page 16

I
1-10
nstallatIon
Apply gasket pad to right end
first, then apply the narrower
Foam Tape Gasket — 3
around the perimeter of the
right end frame outside of
the donut gasket as shown in
Figure 5A, Part 2, 5B or 5C,
Part 2.
RL / RLN
/ / / / / /
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / /
Detail D
Right End
Right End
Overlap
Gasket
P/N 3053328_C
• Lap gaskets at lower
corners.
• Check that there are no
gaps between gasket and case.
• Do not stretch gasket,
especially around corners.
To make sharp corners, paper
backing can be torn without
removing from gasket.
1
2
/////////////////////////////
3
Overlap
Overlap
Foam Gasket
Foam Gasket 3
As Shown
as Shown
1
DETAIL A
Detail A
/
2
3
F
F
R
R
O
O
N
N
T
T
Gasket
Pad
Make sure area where raceway attaches to end frame
is sealed with the wider 1 in. x
Figure 5A, Part 2. Apply Gaskets to Right End
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Right End
Case-to-Case
Right End Case-to-Case
Joint or End Panel
Joint or End Panel
Apply Donut Gasket,
Apply Donut Gasket,
Foam Gaskets and
Foam Gaskets
Gasket Pad to Right
and Gasket Pad to
End Only
Right End Only
Apply Gasket Pad
Apply Gasket Pad
/ in. gasket.
1
2
• Do not butt gaskets; always
lap joints.
• Remove paper backing after
gasket is applied to keep gasket
free of debris.
• Gasket has high tack
adhesive and must be properly
placed the first time.
1. Butyl is NOT an acceptable
substitute for donut or foam
gasket.
1
Foam 1/2 inch x 1/4 inch
Foam 1/2 inch x 1/4 inch
/ / / / / / / /
2
Donut Gasket
Donut Gasket
3
Foam .906 inch x 1/2 inch x 200 inch
Foam .906 inch x 1/2 inch x 200 inch
/////////////////////////////
Install Donut
Install Donut Gasket
Gasket
(seat into groove)
(seat into groove)
Left End
Left End
Left End
Left End
Only Use
Only Use Donut
Donut Gasket on
Gasket on left end
left end of
of a Case-to-Case
a Case-to-Case
If attaching an End
If attaching an End
Panel, all 4 Gaskets
Panel, all 4 Gaskets
must be applied.
must be applied.
Detail C Detail C
F
F
R
R
O
O
Joint
Joint
N
N
T
T
2