Software Configurations; Basic Settings; Change The Id; Remark - HDL SB-DN-1IP User Manual

3 Software configurations

3.1 Basic settings

3.1.1 Change the ID

Each HDL-device has subnet and Device ID and each module's Device ID must be unique
and different from other devices on the same Bus, the subnet ID should be the same as
the HDL-Bus gateway
Method One:
1. Run the HDL-BUS Pro Setup tool.
2. Long press the "programming button" and keep pressing it for 3 seconds until it turns to
a red color.
3. On the software, click ton "Address management", and select
"Modify address (when device button is pressed)" option, it will show a window like
below:
4. click on "Indicate initial address", then it will show the current subnet/device ID of this
module. to modify the address, fill in the new address, and click the "Modify initial
address "Click the "+Add" button, the device will be added to "ON-line devices "list.
Method two:
1- Run HDL-bus pro tool
2- Search for the online devices by clicking on search button and the device will be
displayed on "online device list"

3.1.2 Remark

To give a name to the module, so you can recognize it from other modules.
H D L t y p i c a l g a t e w a y – U s e r M a n u a l
5
(typically the SB-DN-1IP or HDL-MBUS01IP.431).
User Manual
SB-DN-1ip