Dhcp (Auto Ip); Communication Modes - HDL SB-DN-1IP User Manual

User Manual
SB-DN-1ip

3.1.3 DHCP (Auto IP)

Selecting this option allows your 1IP module to assign a dynamic IP address to it from
DHCP server. Instead of manually entering the IP settings, which is time consuming,
performing this procedure will ensure that the module will get the correct TCP/IP settings
automatically. This process is useful when connecting the 1IP module to a network with a
DHCP server
Configuration steps:
a) On the Basic settings tab, check the option "DHCP (auto IP" and save.
b) After that, the module will reboot its self for about two seconds and it will be obtain a
new IP address from the DHCP server.

3.2 Communication modes.

If the firmware of SB-DN-1IP is HDL_V04.02N_2013/05/30 or newer, it supports three
modes, i.e., Local Network mode, P2P mode, and Remote Server mode.
(Tips: when the firmware upgrade finished, better to power off this module for several seconds and power
on this module, then initialize the IP by pressing its button, then power off and power on again.)
After update the SB-DN-1IP, its MAC may reset to "00.00.00.00.00.00.00.00", so needed
change manually. To avoid the possible conflict, there is a suggestion: input its own
Machine Code ( in total 13 digits) as the front numbers of MAC, and the remaining 3
H D L t y p i c a l g a t e w a y – U s e r M a n u a l
6